ESP32 Cam Guide


ESP-32CAM can be widely used in various IoT applications. It is suitable for home smart devices, industrial wireless control, wireless monitoring, QR wireless identification, wireless positioning system signals and other IoT applications. It is an ideal solution for IoT applications.

Arduino Ide Intall Esp-32 Cam Board :-

Front Side 

Back Side

ESP-32CAM adopts DIP package and can be directly inserted into the backplane to realize rapid production of products, providing customers with high-reliability connection mode, which is convenient for application in various IoT hardware terminals.

- The smallest 802.11b/g/n Wi-Fi BT SoC Module
- Low power 32-bit CPU,can also serve the application processor
- Up to 160MHz clock speed,Summary computing power up to 600 DMIPS
- Built-in 520 KB SRAM, external 4MPSRAM
- Support OV2640 and OV7670 cameras,Built-in Flash lamp.
- Support image WiFI upload
- Support TF card
- Supports multiple sleep modes.
- Embedded Lwip and FreeRTOS
- Supports STA/AP/STA+AP operation mode
- Support Smart Config/AirKiss technology
- Support for serial port local and remote firmware upgrades (FOTA)

If you get the error shown above then this is most likely due to incorrect wiring or insufficient power being applied to the board which is causing it to boot-loop or not power at all. If you are using the ESP32-CAM board, then please make sure that you wire the board as shown below and do not forget to connect the 5V power source to the 5V pin.

After Uploading The Code Remove The ID0 to Ground And Check Serial Moniter


  1. How to view in blynk app, please let me know the code also